Osha Safety Gate Standards

13 i has a self closing gate that slides or swings away from the hole and is equipped with a top rail and mid rail or equivalent intermediate member.

Osha safety gate standards.

A dual gate system does not depend on an operator to remember and make an effort to close the barrier. The newest osha revisions include the following criteria for osha 1910 29 b. Another organization you should be familiar with ansi the american national standards institute addresses safety gates in relation to pallet drop areas. Osha and ibc have published regulations for fall protection and ansi has published standards for securing pallet drop areas.

Must be equipped with top rails and mid rails or equivalent intermediate members that meet the requirements in final paragraph b 13 i. Osha requirements have always been a complex topic but osha s walking working surfaces and fall protection standards may have made things even more complicated for some facilities. Must either slide or swing away from the hole. The rule also included a new section that established employer requirements for using personal fall protection systems.

Osha walking working surface regulations. This rule updated general safety standards specific to slip trip and fall hazards. Ladder safety systems and their support systems are capable of withstanding without failure a drop test consisting of an 18 inch 41 cm drop of a 500 pound 227 kg weight. Single barrier systems that meet osha specifications only meet osha when the barriers are closed.

1910 occupational safety and health standards. Osha compliant safety gates from fabenco. Osha s standard requires that a safety gate. Osha provides guidance on walking working surfaces to define the purpose of a safety gate.

Must have a top rail height of 42 inches plus minus 3 inches. We are happy to report that all of our safety gate models even the custom applications comply with these regulations and standards. In ansi mh 28 3 2009 section 6 4 3 a barrier is required to be in place to secure pallet drop areas at all times even while the area is being used for handling materials. Paragraph 1910 23 c 1 requires a standard railing on all open sided floors or platforms 4 feet or more above floor or ground level except at entrances to ramps stairways or fixed ladders.

Included in this are the requirements expectations of employers openings and access points. 1910 28 b 3 iv each employee is protected from falling into a ladderway floor hole or ladderway platform hole by a guardrail system and toeboards erected on all exposed sides except at the entrance to the hole where a self closing gate or an offset must be used. Fall protection systems and falling object protection criteria and practices the employer must ensure guardrail systems meet the following requirements.